View Single Post
Antigo 26-06-2007, 18:16   #5
Spawm
Mazdista
 
Avatar de Spawm
 
Registo: 13-02-2006
Local: Covilhã/Guarda
Posts: 560


Enviar Mensagem via MSN para Spawm
Predefinido

Mais um Teste ao Auto Rádio


LCD Inspection
1. With the audio power on, press the POWER button and simultaneously press the SEEK button (upper) for approx. 1 s.

2) Start the LCD inspection mode.
The characters displayed on the LCD are not truncated or faint. The LCD is normal.

3. Turn the audio off or the ignition switch to the LOCK position to stop the diagnostic assist function.


Button Inspection
1. With the audio power on, press the POWER button and simultaneously press the CLOCK button for approx. 1 s.

2) Start the button inspection mode.
• Press all buttons. - The buzzer sounds. The button is normal.
The buzzer does not sound. Replace the base unit.

3. Turn the audio off or the ignition switch to the LOCK position to stop the diagnostic assist function.


Speaker Inspection
1. With the audio power on, press the POWER button and simultaneously press the AUTO-M button for approx. 1 s.

2) Start the speaker inspection mode.
• Does each speaker output sound in the following order?
A. Front passenger-side door speaker and tweeter
B. Front driver-side door speaker and tweeter
C. Driver-side rear door speaker
D. Passenger-side rear door speaker

3. Turn the audio off or the ignition switch to the LOCK position to stop the diagnostic assist function.


Radio Reception Condition Inspection
1. With the audio power on, press the POWER button and simultaneously press the PRESET 2 button for approx. 1 s.

2. Inspect accordingly.

Caution
• Even if the system is normal, radio reception may be difficult depending on where the system is inspected (indoors/outdoors, or conditions at the location). Before inspecting the system, verify that radio reception is adequate.
• When inspecting, select a frequency band (radio station) with the best reception.

Rating as follows:

5-9 Antenna, antenna feeder and base unit are normal
3-4 Change the frequency (radio station) and inspect again.
0-2 Inspect the antenna and antenna feeder.

• If either the antenna or the antenna feeder is not normal, replace the malfunctioning part.
• If the antenna and antenna feeder are normal, replace the base unit.

3. Turn the audio off or the ignition switch to the LOCK position to stop the diagnostic assist function.
__________________
Mazda 3 HB 1.6MZ-CD
Spawm está offline   Responder com citação